MIG/MAG Gorionici Push-Pull Plus

The welding torches of the Push-Pull Plus series, specially developed for aluminum welding requirements and the use of thin wires, makes problem-free and consistent wire feed and constant wire feed possible, even with longer cable assemblies. A powerful, sturdy pull motor with potentiometer guarantees exact speed regulation. For an optimum wire feed without frictional loss, the contact pressure of the feeding rollers can be regulated precisely and easily directly on the handle. The ergonomic handle ensures optimum, low-fatigue handling.

The screw-type torch necks can be replaced quickly.They are available as either straight or 45° angled versions. A special interface between the handle and the torch neck makes it possible to turn the necks up to 360°. All torches, both air and liquid-cooled for capacities of up to 400 A, are based on the triedand-trusted “MB” torch neck design.

The main areas of application for these welding torches include wharfs, manufacturers of containers and ships etc., as well as in vehicle and wagon building. Wherever exact and constant wire feeding is an absolute must.

• Identical motor characteristics as standard Push-Pull
• Consistent and problem-free wire feeding thanks to a powerful pull motor
• Precise contact pressure regulation of the wire feeding rollers directly on the torch
• Available with optional potentiometer for speed regulation
• Wearing parts are identical to those of the tried and trusted MB torch series – minimised stocking
• Optimum torch cooling – long tool lives
• Sturdy design – long service life

Tehnički podatci (EN 60 974-7):

* prema DIN EN 439

Mjereno korištenjem izvora struje zavarivanja sa VDE standardnom strujno/naponskom karakteristikom (U=14+0,05xl). Kad je u pitanju impulsno zavarivanje snaga je niža 35%.

Tehnički podatci (EN 60 974-7):

* prema DIN EN 439

Mjereno korištenjem izvora struje zavarivanja sa VDE standardnom strujno/naponskom karakteristikom (U=14+0,05xl). Kad je u pitanju impulsno zavarivanje snaga je niža 35%. Preporučljiva snaga uređaja za hlađenje tekučine cca 800W. Kako bi zaštitili polikabel od prekomjernog zagrijavanja preporuča se da se hlađenje nastavi još bar 4minute nakon završetka zavarivanja.